BELL SAGEMCOM 2864 PDF

Plug the power connector into the Sagemcom and plug the other end into an AC wall jack. Note: the Sagemcom takes a long time to boot up, as much as five full minutes Note: This page shows what the Sagemcom lights tell you. Connect an Ethernet LAN cable to one of the ports and the other end to your computer Note: Do not connect anything to the cable coax connection. It should never be connected to any coax cable. If it is unknown then do a reset to factory default, using a paper-clip in the reset hole on the back.

Author:Temi Akinos
Country:Mozambique
Language:English (Spanish)
Genre:Software
Published (Last):13 April 2016
Pages:232
PDF File Size:5.51 Mb
ePub File Size:3.14 Mb
ISBN:144-6-77188-533-7
Downloads:84209
Price:Free* [*Free Regsitration Required]
Uploader:Malalkree



Plug the power connector into the Sagemcom and plug the other end into an AC wall jack. Note: the Sagemcom takes a long time to boot up, as much as five full minutes Note: This page shows what the Sagemcom lights tell you.

Connect an Ethernet LAN cable to one of the ports and the other end to your computer Note: Do not connect anything to the cable coax connection.

It should never be connected to any coax cable. If it is unknown then do a reset to factory default, using a paper-clip in the reset hole on the back. Hold until the power light turns off to reset. The user name and password will now be as above.

While most modems erase the password, reset everything to factory defaults and thus will not connect, the Sagemcom does not erase the password, but it does reset everything else to factory defaults. If the modem is connected to the internet after a reset it will sign on and connect, but will only go to a single Bell website intended to allow Bell customers to sign up. If this occurs then leave the modem on until the LED is no longer flashing red.

No configuration should be attempted until this is complete. A firmware update may result in the loss of user name and password in which case the modem will only connect to the one Bell sign-up website, as mentioned above.

This is an indication that it needs to be reconfigured with this information. Entering the configuration information When the modem interface appears in the browser, proceed as follows: DSL Quick Configuration Info.

AGFA ADC COMPACT PLUS PDF

SAGEMCOM Fast 2864 User Manual

Voodoonos If the modem is connected to the internet after a reset it will sign on and connect, but will only go to a single Bell website intended to allow Bell customers to sign up. This is an indication that it needs to msnual reconfigured with this information. The Sagemcom Router Manhal is a powerful yet simple communication device for connecting your computer or local area network LAN to the Internet. Hold until the power light turns off to reset. To establish a connection from your computer to the Router: To print the manual completely, please, download it.

ARGUEDAS YAWAR FIESTA PDF

Sagemcom 2864 Configuration

Page of 23 Go. A firmware update may result in the loss of user name and password in which case the modem will only connect to the one Bell sign-up website, as mentioned above. A line filter may be included with some models prevents DSL traffic from disrupting the voice signal on the telephone line, and vice manuak. Got it, continue to print. You will need to enter the current Password before entering the new Password two times. Contacting Technical Support If you still cannot resolve the issue after following the recommended troubleshooting procedures, first contact your ISP. To establish a connection from your computer to the Router: No special wiring or cooling requirements are needed; however, you shall comply with the safety guidelines specified in the General Safety Guidelines section.

Related Articles