Dainris Nickel alloy steel Double normalized and tempered for cryogenic service Pressure vessel quality Spec discontinued in Vendors: Users requiring more precise data for scientific or engineering calculations can click on the property value to see the original value as well as raw conversions to equivalent units. The material shall undergo mechanical tests such as tension test and impact test. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. MatWeb is intended for personal, non-commercial use. The steel shall be killed and shall conform to the fine austenitic grain size requirement. Login to see your most recently viewed materials here.
|Published (Last):||14 November 2012|
|PDF File Size:||18.15 Mb|
|ePub File Size:||7.44 Mb|
|Price:||Free* [*Free Regsitration Required]|
More A The steel shall be killed and shall conform to the fine austenitic grain size requirement. All plates shall undergo heat and product analysis and shall conform to the required chemical composition for carbon, manganese, phosphorus, sulfur, silicon, and nickel.
Tensile properties of the steel plate shall meet the specified values for tensile strength, yield strength, and elongation. The material shall undergo mechanical tests such as tension test and impact test. This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
Scope 1. Use of magnets in handling after heat treatment should be avoided if residual magnetism would be detrimental to subsequent fabrication or service.
Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
Jump to navigation Jump to search ASTM A53 is a carbon steel alloy , used as structural steel or for low-pressure plumbing. It is commonly available with national pipe thread ends or with plain cut ends. It can be used for steam, water, and air conveyance. It is also weldable and can be used in structural applications, although ASTM A tube, which is available in the same NPS sizes, is sometime preferred. It shall be permissible to furnish pipe having other dimensions provided that such pipe complies with all other requirements of this specification.
9% Nickel Steel
ASTM A53 steel