Korg AXG - page 2 2 Printing conventions in this manual marks a point of caution. LCD screens printed in this manual ar e only for purposes of illustration, and may not match the actual display on your AXG. Precautions Location Using the unit in the following locations can result in a malfunction. Korg AXG - page 3 3 1. Introduction 1.
|Published (Last):||18 August 2014|
|PDF File Size:||6.50 Mb|
|ePub File Size:||14.72 Mb|
|Price:||Free* [*Free Regsitration Required]|
This knob selects the type of Drive Amp effect that will be used. From the left, these are referred to as value knobs 1—5. When you are not editing an effect, parameters of the drive amp effect used by the selected program are assigned to these knobs.
Refer to p. At this time, the LED beside the switch will change between blinking green channel A and blinking red channel B. The LED beside the corresponding switch will also change between blinking lit and dark. The LED beside the switch will change between blinking and dark. The LED beside the corresponding switch will light or go dark. When the tuner is operating, this shows the amount of pitch deviation.
While the Tuner is operating, it displays the note name. When using a delay effect, you can press the TAP switch at the tempo of the song to set the delay time automatically. When a cable is connected, the power will be turned on. Before turning the power on or off, be sure to turn down the volume of any equipment that is connected. When this is connected, the power will be turned on automatically. When removing the cable from the hook, do not apply tension.
Pass the cable through the guide as shown in the diagram below. When using the cable guide, please use a cable whose diameter is 8 mm or less.
Korg ToneWorks AX1000G Owner's Manual
Korg AX100G User Manual
KORG AX100G Quick Manual