SAE J1199 PDF

Type —austenitic general purpose stainless steel Series—austenitic chromium-nickel-manganese alloys[ edit ] Type —austenitic that is hardenable through cold working Type —austenitic general purpose stainless steel Series—austenitic chromium-nickel alloys[ edit ] Type —highly ductile, for formed products. Also hardens rapidly during mechanical working. Good weldability. Better wear resistance and fatigue strength than

Author:Yoktilar Brasida
Country:Cape Verde
Language:English (Spanish)
Genre:Travel
Published (Last):5 July 2015
Pages:48
PDF File Size:5.79 Mb
ePub File Size:18.49 Mb
ISBN:514-7-83909-567-6
Downloads:29853
Price:Free* [*Free Regsitration Required]
Uploader:Akik



Products included are bolts, screws, studs, U-bolts, preassembled screw and washer assemblies sems , and products manufactured the same as sems except without washer.

Products not covered are tapping screws, thread-rolling screws, and self-drilling screws. Mechanical and material requirements for these products are covered in other SAE documents. The term stud as referred to herein, applies to a cylindrical rod of moderate length, threaded on either one or both ends or throughout its entire length.

It does not apply to headed, collared, or similar products which are more closely characterized by requirements shown herein for bolts. For specification purposes, this document treats U-bolts as studs. Thus, wherever the word studs appears, U-bolts is also implied. U-bolts covered by this document are those used primarily in the suspension and related areas of vehicles.

Designers should recognize that the U configuration may not sustain a load equivalent to two bolts or studs of the same size and grade; thus actual load-carrying capacity of U-bolts should be determined by saddle load tests. Revision History.

CHACONNE BACH BUSONI PDF

SAE steel grades

Products included are bolts, screws, studs, U-bolts, preassembled screw and washer assemblies sems , and products manufactured the same as sems except without washer. Products not covered are tapping screws, thread-rolling screws, and self-drilling screws. Mechanical and material requirements for these products are covered in other SAE documents. The term stud as referred to herein, applies to a cylindrical rod of moderate length, threaded on either one or both ends or throughout its entire length. It does not apply to headed, collared, or similar products which are more closely characterized by requirements shown herein for bolts.

ATA5577 ATMEL PDF

.

Related Articles